Smartcraft Setup Data - NorthStar SMARTCRAFT GATEWAY Manual

Table of Contents

Advertisement

3-7 SmartCraft setup data

To go to the SmartCraft setup data, press
until the Setup menu is displayed, then select
SmartCraft. The setup options are:
Engine faults, Engine fault history, Reset
fault history
See section 3-6.
Troll window
Select from a menu:
On idle: Troll window is displayed when
you press
and the engine is in gear.
Always: Troll window is displayed when you
press
.
Never: Troll window never displayed, troll
control is not available.
Troll mode
Press
to select what troll mode controls:
RPM: Controls engine idle RPM.
Speed: Controls engine idle RPM to try to
achieve the desired boat speed.
See section 3-3, notes 1 and 2
Trim popup
Press
to select:
Off: Trim popup window is never displayed.
On: Trim popup window is displayed when
trim is changed.
Trim popup filter
This filter can stop the trim popup window ap-
pearing because of engine vibration rather than
a trim change.
Press
, then press
. The values are Off and 1 to 5.
press
Select Off or a low value first. Run the boat at a
range of speeds and increase the value if vibration
causes the trim popup window to appear. If the
value is high, the trim window will appear slowly
when trim changes.
Speed range
Set the speed range for an analog speed gauge
(see Gauge type below). The options are High,
Medium and Low. A higher range displays a
higher maximum speed but the display is more
14
and the throttle is at idle
or
to select a value, then
compressed.
Speed type
Press
to select the source of the water (boat)
speed reading:
Pitot: The engine's pitot sensor.
Paddle: A Navman paddlewheel sensor.
The pitot sensor is more accurate at high speeds
but is not accurate at low speeds. The paddle wheel
sensor is more accurate at low speeds. To use troll
speed control, set Speed type to Paddle.
Pitot type
to select 100 psi or 200psi to match
Press
the pitot type installed on the boat.
Gauge type
Press
to select the type of gauges in the Small,
Medium and Large SmartCraft displays (see sec-
tion 3-2):
Analogue: Dial displays (see also Speed
range above).
Digital: Number displays.
NAVMAN
SmartCraft gateways Installation and Operation Manual

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for NorthStar SMARTCRAFT GATEWAY

Table of Contents