NorthStar SMARTCRAFT GATEWAY Manual page 18

4-2-1 Tank status display
The tank level display shows the levels from the
optional level sensors in one or two tanks per
engine (see section 1-1-1).
Before use, each tank must be set up and calibrated
(see section 4-7-1).
An alarm can be set to sound if the level in a tank
is low (see section 4-7-1). These alarms are in addi-
tion to any SmartCraft engine fault low level alarms
(see section 4-5).
4-2-2 Customising the engine data
displays
To customise an engine data display, press
, select SmartCraft, select the display
to customise, and press
display the options:
Data setup
Select the data item to be displayed in the data
header display area (at the top of the display):
1 Press , , or
to change.
2 Select the item by pressing
display a menu of options for the selected
item (the options available will depend on
your engine, see section 1-1).
Press or to select an option, then press
.
20
. Press
to select the data item
. this will
NAVMAN
3 Repeat steps 1 and 2 to change more data
items, then press
main display.
Gauge setup
Select the data to be displayed in the engine data
display areas (not for Tank status display).
1 Press ,
change.
2 Change the gauge:
i Press
tions for the selected gauge (see right;
the options available will depend on your
engine, see section 1-1).
ii Press
press
to
3 Repeat steps 1 to 2 to change more gauges,
then press
display.
Gauge type
Select the type of gauges to be displayed (not for
Tank status display):
Analogue: Dial type displays (see also sec-
tion 4-7: Speed range).
Digital: Number type displays.
Notes:
1 The factory default has gauges appropriate to
the type of engine.
2 To further customise the three gauge dis-
plays, change Speed range, Speed type
and Pitot type (see section 4-7).
SmartCraft gateways Installation and Operation Manual
to return to the
, or to select a gauge to
to display a menu of op-
or to select an option, then
.
to return to the main