1 Introduction
The Navman SmartCraft
or two SmartCraft capable Mercury petrol/gasoline
engines to a SmartCraft capable Navman instru-
ment, such as the FISH 4380, FISH 4600 or TRACK-
FISH 6600. The single gateway is for single engines,
the dual gateway is for twin engines.
Adding the gateway extends the functions of the
Navman instrument, allowing the instrument to:
Display engine data, such as speed, RPM,
pressures, tank levels.
Control troll speed and display trim.
Sound an alarm if it detects an abnormal
engine condition.
This manual describes:
1-1 SmartCraft data available from different engines
The SmartCraft engine data available in a system depends on the type of engine. SmartCraft is a digital engine network
provided on some later model (2002 +) Mercury and Mariner Engines, both in-board and out-board.
Engine data available
Steering Angle
Fuel level
Oil temperature
Oil Pressure
Engine Trim
Water Pressure
Engine temperature
Fuel Flow
Fuel Level
Engine voltage
Pitot water (boat) speed
RPM
4
gateway connects one
TM
NAVMAN
How to install a Navman SmartCraft gateway.
How to use the SmartCraft functions of a Nav-
man SmartCraft capable instrument. Refer to
the separate Navman instrument Installation
and Operation Manual for information on how
to install and use the instrument.
The engine data available in a system depends
on the type of engine used (see section 1-
1). The gateway replaces any fuel flow sen-
sors that might be plugged into the Navman
instrument .
It is vital to read this document and the associated
SmartCraft and Navman installation and operation
manuals before installing or using the system.
Engine type
SmartCraft gateways Installation and Operation Manual