Setting Up The Fish 4600 For Smartcraft; Smartcraft Engine Data Displays - NorthStar SMARTCRAFT GATEWAY Manual

5-1 Setting up the FISH 4600 for Smartcraft

There are two SmartCraft items in the FISH 4600
System setup menu. To display the System menu,
press until the Setup menu is displayed,
then select System.
Sonar
Select: For normal sonar operation
De-select: To disable the sonar transducer
and sonar functions. For use
with the instrument's SmartCraft
functions only,
SmartCraft
Select: Normal SmartCraft operation
De-select: SmartCraft functions. The instru-
ment will now use any Navman
fuel sensors which are connected.

5-2 SmartCraft engine data displays

There are four SmartCraft engine displays, shown below.
Note: If the boat has twin engines, two needles will appear on most of the gauge displays. The red needle
or number shows port engine data, green shows starboard engine data.
Engine data display area
Small: Eight small gauges
Shows eight small
gauges. Press
, select SmartCraft,
then select Small.
28
Medium: Two medium, four
small gauges
Shows two large and
four small gauges.
Press , select
SmartCraft, then
select Medium.
NAVMAN
Note:
SmartCraft utilises NavBus comms. NavBus will
turn on if SmartCraft is turned on.
Data header display area
Large: Two large gauges
Shows two large
gauges. To display this,
press , select
SmartCraft, then
select Large.
SmartCraft gateways Installation and Operation Manual
Tanks: Tank levels
Shows the levels in the
tanks. To display this,
press , select
SmartCraft, then
select Tanks.