Advertisement
Available languages
Available languages
1
/
" Screw
1
4
with Washer
Mantel Side
Assembly
Figure 4 - attaching mantel top
FOR DImPlex FIRePlACe Use ONly
If you are installing a Dimplex Electric Fireplace in this mantel,
you will need to follow the instructions in this section. If you
are not installing a Dimplex Electric Fireplace, go to Finishing
Mantel and discard items #8, #9 and #10
1. Place Dimplex filler panel (#9) in position in front of mantel
with trim strip to outside covering joint between filler panel
and mantel (see Figure 5).
2. With one person holding filler panel in place, attach filler
assembly block (#8) to top of filler panel and bottom of
extension using four 1
completely tighten screws.
Dimplex Filler
Assembly
Block (#10)
1
/
" Screw
1
4
with Washer
Dimplex
Filler
Assembly
Block (#8)
1
/
" Screw
1
4
with Washer
Figure 5 - attaching Dimplex Filler panel
121340-01B
Mantel Top (#7)
Header
/
" screws with washers. Do not
1
4
Dimplex Filler
Panel (#9)
Dimplex
Filler
Assembly
Block (#10)
3. Attach assembly blocks (#10) to sides of filler panel and
mantel side assemblies using two 1
ers for each side. Do not tighten completely.
4. With one person holding parts in alignment, tighten
screws snuggly with Allen wrench provided. Do not over
tighten.
FINIsHING mANtel
Starting with left side leg assembly, tighten screws using Allen
wrench provided. Tighten screws on the right side leg assembly,
header, top assembly and base. When using Dimplex filler
panel, align and tighten at same time as header.
GAs FIRePlACe INstAllAtION
1. Fireplace should be fully assembled. See Assembling
Fireplace in fireplace owner's manual.
2. Place mantel base close to installation location. See fire-
place owner's manual for installation clearances. Leave
enough room to insert fireplace from back of mantel.
3. Install gas line. See Connecting to Gas Supply in fireplace
owner's manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See Checking Gas Connections in fire-
place owner's manual.
5. Position fireplace inside mantel (see Figure 6). Carefully
position gas lines. Important: Use caution when position-
ing fireplace on base. Base may scratch easily. Make
sure fireplace is in proper position within mantel opening
before continuing with installation.
6. Fireplace with louver door: Lower bottom louver door.
Use two screws provided in hardware package and attach
fireplace to wooden base. Close louver door.
Fireplace with fixed louver: Before installing logs or
burner assembly (see owner's manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base. Reinstall floor with screws removed previously.
www.desatech.com
/
1
Figure 6 - Installing Fireplace
" screws with wash-
4
3
Advertisement
