Advertisement
FiRePlACe instAllAtiOn
1. Fireplace should be fully assembled. See Assembling
Fireplace in fireplace owner's manual.
2. Place mantel base close to installation location. See fire-
place owner's manual for installation clearances. Leave
enough room to get behind mantel once fireplace and
mantel assembly have been attached to base if installing
a fireplace with flange.
3. If installing gas fireplace, install gas line. See Connecting
to Gas Supply in fireplace owner's manual. Remember
to leave access to the gas shutoff valve somewhere on
the base or where it is accessible to the user. Check
for leaks. See Checking Gas Connections in fireplace
owner's manual.
IMPORTANT: If your fireplace has a nailing flange see Installing
Fireplace with Flange. If your fireplace does not have a nailing
flange see Installing Fireplace without Flange, page 4.
instAlling FiRePlACe With FlAnge
1. Position fireplace on base centering left to right. Care-
fully position gas lines. IMPORTANT: Use caution when
positioning fireplace on base as base may scratch.
2. With assistance, carefully place mantel over fireplace (see
Figure 6). Fireplace nailing flanges will be to the inside of
mantel. Align mantel over threaded holes in base. Make
sure back of mantel is flush with back of mantel base.
Adjust fireplace as necessary.
Shoulder
Screw
Figure 6 - Installing Fireplace with Flange
121558-01A
3. Attach mantel to base using 6 brackets and 1/2" screws,
4. Adjust fireplace so that it fits into mantel opening properly.
5. Gas fireplace with louver door: Lower bottom louver door.
6. If using perimeter trim that came with your mantel and
8. Carefully push mantel and base into position against wall.
Bottom
Louver Door
Shoulder
Screw
Gas Line
Access Hole
Possible
Shutoff Valve
Figure 8 - attaching Gas Fireplace to mantel and mantel Base
Locations
Mantel
Base
www.desatech.com
3 per leg assembly, into threaded holes in base and leg
assembly (see Figure 7).
Use two screws provided in fireplace hardware package
and attach fireplace to wooden base (see Figure 8). Close
louver door.
Gas fireplace with fixed louver: Before installing logs or
burner assembly (see owner's manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base (see Figure 9, page 4). Reinstall floor with screws
removed previously.
it has not yet been assembled, see Assembling Perim-
eter Trim, page 5. Place metal trim on shoulder screws
on fireplace. Firmly snap trim assembly over shoulder
screws.
Figure 7 - attaching mantel assembly to mantel Base
Hole for Attaching
Fireplace System to
Wooden Mantel Base
Bracket with 1/2"
Screws
3
Advertisement
