Advertisement
Available languages
Available languages
7. If mantel trim that came with your fireplace has not yet
been assembled, see Assembling Perimeter Trim. Place
metal trim on shoulder screws. Firmly snap trim assembly
over shoulder screws on fireplace.
8. Carefully push mantel and base into position against
wall.
AssemblING PeRImeteR tRIm (If supplied
with Gas Fireplace)
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 7.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 7).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 7).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Adjusting
Plate
Shim
eleCtRIC FIRePlACe INstAllAtION
This mantel can be used with Dimplex 32" Electric Fireplace.
Electric fireplaces install from the front of mantel. To install
electric fireplace see fireplace instruction manual. Use cau-
tion when positioning fireplace on base. Base may scratch
easily.
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
1-866-672-6040
Slot
Set Screws
Slot
Figure 7 - assembling trim
Top Trim
Mitered Edge
Side Trim
121340-01
Rev. B
05/07
Advertisement
