Advertisement
AsseMblING MeTAl TRIM
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 11.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 11).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 11).
6. While firmly holding edges of trim together, tighten both set
screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 2 through 6 for other corner.
Set Screws
Adjusting
Plate
Shim
Slot
Figure 11 - assembling metal trim
FIRePlAce INsTAllATION
1. Fireplace should be fully assembled. See Assembling
Fireplace in fireplace owner's manual.
2. Place mantel base close to installation location. See fire-
place owner's manual for installation clearances. Leave
enough room to get behind mantel once fireplace and
mantel assembly have been attached to base if installing
a fireplace with flange.
3. Install gas line. See Connecting to Gas Supply in fireplace
owner's manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See Checking Gas Connections in fire-
place owner's manual.
IMPORTANT: If your fireplace has a nailing flange see Installing
Fireplace with Flange. If your fireplace does not have a nailing
flange see Installing Fireplace without Flange, page 5.
Installing Fireplace with Flange
1. Place mantel assembly on wood base and center left to
right having back of assembly flush with back of base.
Mark placement on base along inside front of mantel
assembly. Remove mantel assembly from base.
2. Position fireplace on base, centering left to right between mark-
ings. Carefully position gas lines. IMPORTANT: Use caution
when positioning fireplace on base as base may scratch.
3. With assistance, carefully place mantel over fireplace
(see Figure 12). Fireplace nailing flanges will be to inside
of mantel. Align mantel with markings made previously.
Make sure back of mantel is flush with back of mantel
base. Adjust fireplace as necessary.
4. Attach mantel to base using 1
holes. Using brackets and 1/2" or 3/4" screws from
bracket hardware kit, attach brackets to base and mantel
assembly using one bracket at each back corner of leg
sides and one on each leg front (see Figure 13).
5. Adjust fireplace so that it fits into mantel opening properly.
4
Slot
Top Trim
Mitered Edge
Side Trim
/
" screws through pocket
1
4
Screw
(Side view
for clarity)
Shoulder
Screw
Assembled
Metal Trim
Figure 12 - Installing Fireplace with Flange
Bracket with
1/2"-3/4"
Screws
Mantel Base
Figure 13 - Installing Brackets to mantel Base
www.desatech.com
Gas Line
Access Hole
Possible
Shoulder
Shutoff Valve
Screws
Locations
Mantel Base
Bracket with
1/2"-3/4"
Screws
119794-01A
Advertisement
