Advertisement
Assembly
Blocks
1
/
"
1
4
Screws
Figure 5 - Installing mantel top
IMPORTANT: Align mantel top left to right before installing.
Back corner of mantel leg must be flush with edge of mantel
top before installation.
IMPORTANT: If installing a gas fireplace, vertical support
will be installed to mantel assembly after gas fireplace has
been installed. If installing electric fireplace, first install verti-
cal support and install fireplace from front of mantel. Do not
put any weight on mantel top until vertical support has been
installed.
123754-01A
Fireplace Installation
1. Fireplace should be fully assembled. See Assembling
Fireplace in fireplace owner's manual.
Mantel Top
Assembly
2. Mantel must be installed flush with two walls. Remove
baseboard along walls where mantel is to be installed.
Baseboard will prevent proper installation of mantel and
base.
3. Place mantel base close to installation location. See fire-
place owner's manual for installation clearances. Leave
enough room to insert fireplace from back of mantel.
4. If installing gas fireplace, install gas line. See Connecting
to Gas Supply in fireplace owner's manual. Remember to
leave access to gas shutoff valve somewhere on mantel
Assembly
Blocks
base or where it is accessible to user. Check for leaks.
See Checking Gas Connections in fireplace owner's
manual.
Corner
5. Position fireplace inside mantel through back opening
of Mantel
(see Figure 6). Carefully position gas lines if applicable.
Legs Must
IMPORTANT: Use caution when positioning fireplace on
be Flush
base. Base may scratch easily. Make sure fireplace is in
with Edge
of Mantel
proper position within mantel opening before continuing
Top (Both
with installation.
Sides)
6. Gas fireplace with louver door: Lower bottom louver
door. Use two screws provided in fireplace hardware kit
and attach fireplace to wooden base. Close louver door.
Gas fireplace with fixed louver: Before installing logs
or burner assembly (see owner's manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware kit and attach fireplace base to wooden base.
Reinstall floor with screws removed previously.
Mantel
Legs Flush
with Mantel
Base
www.desatech.com
Figure 6 - Installing Gas Fireplace
3
Advertisement
