Advertisement
Available languages
Available languages
leG Assembly
1. Lay right side panel (#2) face down on a soft surface to
avoid marking finish. Attach four brackets with 1/2" screws
to right side panel (#2) leaving screws slightly loose. Face
brackets out toward tongued side (see Figure 1). Place
right front leg over right side (#2) matching groove in leg
to tongue on side, as shown in Figure 1. Align threaded
holes with brackets on side. Start four 1/2" screws through
brackets. Align bottom of side and leg assembly so they
are flush with each other. Hold these pieces securely
while tightening (but not over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
3. Attach 6 brackets to base (#1) at threaded hole locations
using 1/2" screws leaving screws loose. Face brackets
toward outside.
Leg Front (#3)
1
/
" Screw
1
4
with Washer
Corbel
Tongue on
Leg Side
Figure 1 - Leg assemblies (right side shown)
Right
Side/Leg
Assembly
Bracket
1/2" Screw
Figure 2 - Leg assembly to Base
2
Groove in
Bracket
Leg Front
1/2" Screw
Leg Side (#2)
Base (#1)
www.desatech.com
4. Place right side/leg assembly on base and align threaded
holes with brackets. Start 1/2" screws through brackets
into threaded holes in side/leg assembly. Back of side/
leg assembly should be flush with back of base. Assure
alignment is correct and spaces are at a minimum and
tighten leaving screws slightly loose.
5. Assemble left side/leg assembly to base (#1) following
step #4.
HeADeR Assembly
1. Start two 1
1
/
" screws with washers through header as-
4
sembly block (#8) into threaded inserts on right side of
mantel. Repeat for left side (see Figure 3).
2. With arrow pointing up, place header (#6) into position on
top of leg assemblies and against header assembly block
(#8) (see Figure 3). Start two 1
through header assembly blocks (#8) into threaded in-
serts in header. Hold header in proper alignment with leg
assemblies and tighten, leaving screws slightly loose.
1
/
" Screw
1
4
with Washer
Header
Assembly
Block (#8)
Figure 3 - attaching Header
mANtel tOP Assembly
Place mantel top (#7) on mantel assembly. Align back of top
with back of sides. Using four 1
place two in each mantel side assembly (see Figure 4, page
3). With two 1
/
" screws with washers, attach top to header.
1
4
Make sure all pieces are aligned properly and tighten, leaving
screws slightly loose.
/
" screws with washers
1
4
Header (#6)
Header
Assembly
Block (#8)
1
/
" Screw
1
4
with Washer
/
" screws with washers,
1
4
121340-01B
Advertisement
