Troubleshooting - Yamaha YSP-3000bl Owner's Manual

Troubleshooting
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the AC power supply cable, and
contact the nearest authorized Yamaha dealer or service center.
• General
Problem Cause Remedy
See
page
This unit falls to turn on The AC power supply cable is not firmly Connect the AC power supply cable firmly
29
when STANDBY/ON Is connected to the AC wall outlet. to the AC wall outlet.
pressed, or enters the
This unit has been exposed to a strong Set this unit to the standby mode, disconnect
standby mode soon after the
-
power has been turned on.
external electric shock (such as lightning the AC power supply cable, plug it back in
and strong static electricity). after 30 seconds, and use it normally.
This unit suddenly enters the
The internal temperature becomes too high Wait for about one hour for this unit to cool -
standby mode.
and the overheat protection circuitry has down and tum it back on.
been activated.
The sleep timer has turned the unit off. Tum on the power and play back the source -
again.
No sound.
Incorrect input or output cable connections. Connect the cables properly. If the problem 19
persists, the cables may be defective.
No appropriate input source has been Select an appropriate input source with 45
selected. INPUT or the input selector buttons.
The volume is turned down. Tum up the volume. 47
The sound is muted. Press MUTE or VOLUME +/- to resume
47
audio output and adjust the volume level.
The signals this unit cannot reproduce (such
Playa source whose signals can be
-
as PCM signals with more than 96 kHz of reproduced by this unit.
sampling frequency) are being received
Change the system settings of the source
from the source component.
-
component.
The HDMI components connected to this Connect the HDMI components that support 20
unit do not support the HDCP copy
the HDCP copy protection standards.
protection standards.
SUPPORT AUDIO is set to OTHER and Set SUPPORT AUDIO to YSP-3000 in 82
HDMI audio signals are not being played MANUAL SETUP
back on this unit.
The sound suddenly goes
The sleep timer has turned this unit off.
Turn on the power and play back the source -
off. again.
The sound is muted.
Press MUTE or VOLUME +/- to resume
47
audio output and adjust the volume level.
No sound from the effect You are playing back the source or program
Press one of the beam mode buttons on the
54
channels. in the 2-channel stereo playback or My
remote control to select a multi-channel
Beam mode.
playback mode and play back the source or
program once more.
No sound from the center The output level of the center channel is set
Raise the level of the center channel.
84
channel. to minimum.
No sound from the surround The output level of the surround channels is
Raise the output level of the surround
84
channels. set to minimum. channels.
102
En