Yamaha YSP-3000bl Owner's Manual page 98

Adjusting the system parameters
4
Press
<1/1>
to switch between "F.PANEL:
ON" and "F.PANEL: OFF".
+
F.F'RNEL: ON
F.F'RNEL: OFF
:1
:1
You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
After perfonning the following procedure you must run AUTO
SETUP again to match your surround sound environment.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 88.
2
Set the operation mode selector to YSP.
3
Press
b.. / 'V
so that "FACTORY PRESET" is
displayed in the front panel display.
4
Press ENTER.
+
• Select EPANEL: ON to enable the front panel
keys.
• Select EPANEL: OFF to disable the front panel
keys. "P.INPUT" is automatically set to "ON".
5
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
~
The new setting will be activated when you tum on
the power of this unit next time.
94
En
FRCTOP'/ F'PE5ET