Yamaha YSP-3000bl Owner's Manual page 108

Troubleshootmg
• Remote control
Problem
Cause Remedy
See
page
The remote control does not
Wrong distance or angle. The remote control functions within a
30
work and/or function
maximum range of 6 m (20 ft) and no more
properly.
than 45 degrees off-axis from the front
panel.
Direct sunlight or lighting (from an inverter
Reposition this unit.
-
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The batteries are weak. Replace all batteries.
30
Cannot operate external
The external component you want to operate Press INPUT on the front panel or the input
45
components with the remote
is not selected as the input source.
selector buttons on the remote control to
control of this unit.
select the external component you want to
operate.
The remote control code was not correctly Set the remote control code correctly or try
96
set. another code for the same manufacturer
using the "List of remote control codes" at
the end of this manual.
Even if the remote control code is correctly Use the remote control supplied with the
-
set, there are some models that do not external component.
respond to the remote control.
The cursor buttons do not The operation mode selector was Set the operation mode selector to YSP.
-
work during SET MENU
unwantedly set to TV/AV.
operation.
Cannot use the My Beam
Wrong distance or angle.
The remote control functions within a 30
auto-adjust function.
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front
panel.
• HOMI
Error message Cause Remedy
See
page
Device Error
The number of the connected HDMI Reduce the number of the connected HOMI -
components exceeds the limit. components.
HDCP Error
HDCP authentication failed. Check that the connected HOMI -
components support the HOCP copy
protection standards.
• FM tuner
Problem
Cause Remedy
See
page
FM stereo reception is noisy.
The characteristics of FM stereo broadcasts Check the antenna connections.
29
may cause this problem when the
transmitter is too far away or the antenna
Try using a high-quality directional FM -
input is poor.
antenna.
Use the manual tuning method.
49
There is distortion, and clear
There is multi-path interference. Adjust the antenna position to eliminate -
reception cannot be obtained
multi-path interference.
even with a good FM
antenna.
The desired station cannot
The signal is too weak. Use a high-quality directional FM antenna.
-
be tuned into with the
automatic tuning method.
Use the manual tuning method. 49
Previously preset stations
This unit has been disconnected for a long Preset the stations again.
50
can no longer be tuned into.
period.
104
En