Yamaha YSP-3000bl Owner's Manual page 121

o
Set the operation mode selector
to YSP.
This unit sWitches 10 the YSP operation mode.
G!>
Press ENTER to start the AUTO
SETUP procedure, and then
leave the room within 10 seconds.
The following SCfeen appears on the TV. Leave the room
wilhin 10 seconds before IheAUTO SETUP procedure
starts
I ~A~I'"
.~ii"
;/; ~I.P $lifT
,
...
... .
"
.,
• Press and hold AUTO SETUP for
more than 2 seconds.
The menu sCleen appears on the TV.
I! the menu screen does nol appear, check the OSD video
pin cable (see the connection example on the front page).
e
Check the following points.
About the IntelliSeam microphone
• Is the microphone placed on an Imaginary center line drawn
from thiS unit?
• Is the microphone placed within 1 m (3,3 ttl upper or lower
from the center height of thiS unit?
• Is the microphone placed more than 1.8 m (60 II) from the
tront of thiS unlj?
Aboullhe room environment
• Is your listening room kept as qUiet as possible?
CD
Prepare to leave the room.
The best selting may nOI be done if you are in the room.
, E
"' ....
• When leaVing the room. bnng thiS gUIde With you,
• Wall outside the room during the AUTO SETUP procedure.
• The AUTO SETUP procedure lakes . :
• To cancel the AUTO SETUP procedure atter 1\ is started.
press RETURN
The setup screen aUlomatically changes during the AUTO
SETUP procedure.
When the AUTO SETUP procedure
IS
completed, the
follOWing screen appears on lhe TV.
~:~ ;[~.-
..
~.,,~
,.
....
" ,
...
'u '" , ,
",
...
,
..
,-
.
..,
..
II "ENVIRONMENT CHECK (FAILED)
IS
displayed. see page
40 in the Owner's Manual and then run the procedure again.
*HInI
• The result may diller depending on the envlronmenl
• If any error occurs, the corresponding error message appears
on lhe screen. In this case. see -Error messages lor AUTO
SETUP' on page 41 10 the Owner's Manual and lhen !ollow
lhe inslructlons. To startlhe AUTO SETUP procedure once
again. press RETURN
CD
Press ENTER.
The follOWing screen appears on the TV for 2 seconds and
then the menu screen disappears 'rom the TV,
4B
Disconnect the IntelliBeam
microphone.
The AUTO SETUP has completed, Keep the IntelilBeam
microphone In a safe place
The setlings are automatically saved in lhe system memory.
•
-.-jf----~.
a . . . . . .