Notes To Operators And Key Operators; The Following Safety Rules Should Be Observed; Fcc Part 15 - Radio Frequency Devices (For U.s.a. Users); Warning - Konica Minolta MS7000 MK II User Manual

Notes to Operators and Key Operators

1 Notes to Operators and Key Operators
1.1

The following safety rules should be observed

1. The unit should be kept free from moisture, dirt, dust and exposure to
heat and direct sunlight at all times.
2. Keep hands, hair and clothing away from rollers and other moving
parts.
3. Before removing the Projection Lamp Unit, confirm that the machine is
turned "OFF".
4. Be sure that the proper voltage is used and that the machine is well
grounded.
The use of electrical extension cords is strongly discouraged.
5. For best performance, only our authorized supplies are recommended
for use with this unit. Failure to use our authorized supplies may cause
damage to the unit, in which case the warranty may be rendered void.
6. Do not attempt to remove any Cover that is secured.

FCC Part 15 - Radio Frequency Devices (For U.S.A. Users)

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.

WARNING

This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
The design and production of this unit conforms to FCC regulations, and
any changes or modifications must be registered with the FCC and are
subject to FCC control. Any changes made by the purchaser or user
without first contacting the manufacturer will be subject to penalty under
FCC regulations.
1
1-1