Enabling And Disabling The Scanner; Enabling The Scanner - Kodak I810 - Scanner Firmware - PC User Manual

Enabling and disabling
the scanner

Enabling the scanner

3-2
The five buttons at the bottom of the Control Panel correspond to the
icons above the buttons To activate the icons, press the corresponding
button.
The scanner can only be enabled from the host computer. When the
scanner is enabled, you can change the image address level, override
the elevator setting and use the programmable keys. When enabled, the
icons on the Operator Control Panel will look like this:
These functions can be performed when the scanner is enabled:
Increments the image address level. Depending on the image
address level the icon may appear as follows:
indicating the next image address is level 3
indicating the next image address is level 2
indicating the next image address is level 1
Lowers the elevator tray if it is not already in the lowest
position.
Performs the first programmable function.
Performs the second programmable function.
Performs the third programmable function.
NOTE: Programmable keys are set-up during application setup. Check
with your system administrator for the function of each
programmable key. Possible programmable key assignments
are as follows:
No scanner functionality (default)
Scanner End-of-Job
Terminate Batch
Omit Multi-feed Detection on Next Document
Omit Printing on Next Document
Omit Patch Reading on Next Document
Icons
Control panel
buttons
A-61169 January 2005