Backguard Installation - Thermador PRG364JDG Installation Manual

Backguard Installation

PRG366JG
PRL366JG
PRG364JDG
PRL364JDG
PRG486JDG
PRL486JDG
WARNING:
To reduce the risk of fire or injury to persons,
check to make sure all packaging has been
removed from accessory devices before use.
WARNING:
Fingers or hands could get pinched when
installing the backguard. Severe injury could
result. Use extreme caution and wear thick
protective gloves to avoid potential laceration to
finger or hand while sliding the backguard down
onto the range.
CAUTION:
The High Shelf can get very hot! DO NOT place
the following items on top of the High Shelf:
• plastics or containers that can melt
• flammable items
• a total load over 30 pounds (13.6kg)
High Shelf
Low Back
Figure 16: High Shelf & Low Back Front View
AVAILABLE FOR THESE MODELS:
®
Pro Grand 36" Gas Range 6 Burner
®
Pro Grand 36" Gas Range 6 Burner - LP
®
Pro Grand 36" Gas Range 4 Burner Griddle
®
Pro Grand 36" Gas Range 4 Burner Griddle - LP
®
Pro Grand 48" Gas Range 6 Burner Griddle
®
Pro Grand 48" Gas Range 6 Burner Griddle - LP
Note: If a backsplash is to be used in addition to a back-
guard, install the backsplash first and the backguard sec-
ond before sliding range into place.
High Shelf Parts Included
(1) High Shelf top panel
(1) High Shelf front panel
(13) T-20 Torx Stainless screws
(16 or 14) T-20 Torx drill point screws
(1) Installation Guide
Low Back Parts Included
(1) Low Back panel
(9 or 8) T-20 Torx stainless screws
(8 or 6) T-20 Torx drill point screws
(1) Installation Guide
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
English 21