Step 8: Backguard Installation (Optional) - Thermador PRG364JDG Installation Manual

Step 8: Backguard Installation
Installation methods will vary upon need. Before you begin read these instructions carefully. Observe all local
codes and ordinances.
WARNING:
To reduce the risk of fire or injury to persons,
check to make sure all packaging has been
removed from accessory devices before use.
Backsplash Installation
(PA [30,36, 48] JBS)
The backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the backsplash.
Parts Included
(10) 1" (25.4mm)
screws
(1) Backsplash
(1) Installation Guide
• To protect against scratches, leave protective film on
backsplash until after installation is complete.
• If range is already installed, refer to the manufacture's
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
(optional)
Tools Needed
Phillips screwdriver or
drill
Tape measure
Pencil
1. Locate and lightly mark wall studs.
• Wall studs are usually installed with a 16" or 24"
(406mm or 1372mm) space on center.
2. The height of the hood will determine the height of the
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the hood over-
laps the backsplash 1
3. Per each wall stud, use (2) of the provided screws to
secure both the top and bottom of the backsplash (see
Figure 11).
• Due to variable wall stud widths and varying
backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
(760mm, 913mm, 1218mm)
1
/ " (38mm).
2
30", 36", 48"
Space screws evenly
across top & bottom
Figure 11: Backsplash Installation
English 17