High Shelf Assembly - Thermador PRG364JDG Installation Manual

Backguard Kit Model Numbers
Model 36"
Low Back PA36JLBG
High Shelf PA36JHSG
Flush Island Included on
Trim Range
The backguard must be attached before sliding the range
into the final installed position. When there is less than a
12" (305mm) horizontal clearance between combustible
surfaces ∆ and the back edge of the range above the cook-
ing surface, a THERMADOR
must be purchased separately and installed. When clear-
ance to combustible surfaces
island installations, the supplied THERMADOR
Island Trim may be used.

High Shelf Assembly

(12x) screws along the back
1. Remove protective plastic.
2. Slide the shelf onto the backguard channel.
3. Install the included (5) stainless screws along the
topside of shelf and (8) stainless screws into the back
of the shelf.
4. Begin with Backguard Installation.
English 22
48"
PA48JLBG
PA48JHSG
Included on
Range
®
Low Back or High Shelf
∆ is over 12" (305mm) or for
®
Flush
Figure 17: Backguard Rear View
Backguard Installation
High Shelf
Low Back
Flush Island Trim
(Included with range)
Mounts inside back panel flange
1. Remove protective plastic.
2. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim, the (4) drill point screws securing the trim
to the side panels, and the (2) or (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws in the new backguard's front and
back panels.
6. Re-install (4) drill point screws to secure the
backguard's back panel to the side panels on the back
of the range.
Figure 18: Backguard Installation