Installer Final Check List; To Clean And Protect Exterior Surfaces - Thermador PRG364JDG Installation Manual

Installer Final Check List

Specified clearances maintained to cabinet surfaces.

Unit level and leg covers have been installed

Burner caps positioned properly on burner bases.

All packaging material removed.

Flush Island Trim or backguard attached according to

instructions.
Door Trim reinstalled (see Figure 5 on page 9).

The griddle plate is correctly positioned, tilted slightly,

water-test performed.
Check door alignment and adjust if necessary.

Gas Supply
Gas Connection: 3/4" (19mm) N.P.T. with a min. 3/4"

(19mm) diameter flex line.
The appliance is connected only to the type of gas for

which it is certified for use.
Manual gas shut off valve installed in an accessible

location (without requiring removal of range).
Unit tested and free of gas leaks.

If used on propane gas, verify that the propane gas

supply is equipped with its own high pressure
regulator in addition to the pressure regulator supplied
with the appliance.
Owner is aware of location of the gas shut-off valve.

Gas supply pressure does not exceed 14" W.C. (34.9

mb).

To Clean and Protect Exterior Surfaces

The stainless steel surfaces may be cleaned by wiping with
a damp soapy cloth, rinsing with clear water and drying
with a soft cloth to avoid water marks. Any mild glass
cleaner will remove fingerprints and smears.
For discolorations or deposits that persist, refer to the Use
and Care Manual.
To polish and protect the stainless steel, use a cleaner/
polish such as Stainless Steel Magic
DO NOT allow deposits to remain for long periods of time.
DO NOT use ordinary steel wool or steel brushes. Small
bits of steel may adhere to the surface causing rust.
®
.
Electrical
Receptacle with correct over-current protection is

provided for service cord connection.
Proper ground connection.

Owner is aware of location of the main circuit breaker.

A NEMA 5-20, 120 VAC receptacle is used for gas

range models with electric griddle with 20 AMP over-
current protection.
Operation
Bezels centered on burner knobs, and knobs turn

freely.
Each burner lights satisfactorily, both individually and

with other burners operating.
Oven door hinges seated and hinge locks in proper

position. Oven handle and door is level and centered.
Door opens and closes properly.
Burner grates correctly positioned, level, and do not

rock.
Flame characteristics checked on all burners, and air

shutter(s) on oven bake burner(s) properly adjusted (if
necessary).
INSTALLER: Write the model number and serial

number found on the Rating Label Plate in the
AND CARE MANUAL
the right side of the range between the oven cavity
and side panel). Leave
the
INSTALLATION MANUAL
appliance.
DO NOT allow salt solutions, disinfectants, bleaches or
cleaning compounds to remain in contact with stainless
steel for extended periods. Many of these compounds
contain chemicals which could prove harmful. Rinse with
water after exposure and wipe dry with a clean cloth.
on page 32 (plate is located on
USE AND CARE MANUAL
with the owner of the
English 29
USE
and