Using The Oven; Oven Controls; Kitchen Timer; Cook Timer - Thermador PRD486JDGU Use And Care Manual

Using the Oven

Extended Cooking Functions
Oven Setting Controls
1. ENTER verifies a selection
- +
2. ( ) decreases and (
temperatures, it is also used to scroll through menu
items: Kitchen Timer, Cook Timer, Offset, and
Sabbath oven functions.
3. CANCEL clears all oven operations.
Figure 26: Oven Setting Controls

Kitchen Timer

The Kitchen Timer can be set for up to 12 hours. It can be
used despite whether the range is in operation and
independently of all other functions. The kitchen timer is
non-operational when the steam oven is in a cooking mode
(PRD486JDSG model only).

Cook Timer

The Cook Timer is intended to mechanically shut the oven
off when the desired cooking time is complete. Cook timer
is only available for Bake, Convection Bake, Roast, and
Convection Roast. It is not available for Broil, Convection
Broil, or Self Clean. The Cook Timer can be activated at
anytime during the cooking cycle.
) increases time and/or
To set the timer:
1. Press ENTER.
2. Use the "+" and "-" buttons to select either KITCHEN
TIMER or COOK TIMER.
3. Press ENTER.
4. Press the "+" and "-" buttons to select desired time.
5. A beep sounds when the timer ends. Press CANCEL
terminate the beep and timer.
Note:
• Cook Time cannot be used if a temperature probe
is in use.
• The maximum Cook Time setting is 12 hours.
Using the Offset Feature
The OFFSET feature is located at SETTINGS > OFFSET. It
allows the cook to further fine-tune their cooking
parameters to their own personal optimal settings by
allowing them to adjust the temperature offset of the oven
by +/-95°F (35°C) in increments of 5°F. For example, if the
cook judges the oven temperature as too hot and wants to
lower it by 5°, press the "-" button, and vice versa for
positive temperatures. This feature is useful if you find that
food is consistently either too brown or too light for your
tastes.
• The oven must be turned off in order to set an offset
value.
• The Offset feature is available for all modes except
Self-Clean.
• By default, the temperature is set at 0°.
• The unit will continue to run the inputted offset value
indefinitely until the user manually chooses to render it
otherwise or until the unit loses power, in which case
Offset will need to be reset.
English 23