Ricoh Aficio MP W3600 General Settings Manual page 53

When using thin, soft, or limp paper, toner fusing may appear wrinkled or the
image may be blurred. If this happens, change the thickness level to 3 → 4 → 5.
When level 1 or 2 are selected for translucent paper, and you change the paper
type from plain or film to translucent, it may take longer for the machine to
get ready for copying (up to two minutes).
When level 1 or 2 are selected for translucent paper, and you make copies on
paper of size A1 or above continuously, the interval between each copying
may take longer. Even if you make copy on one sheet only, it may takes 1
minute until the next copy job starts.
❖ Paper Thickness: Paper Bypass
Specify the thickness of paper placed in the paper bypass.
If the copy image blurs or the translucent paper becomes loose, changing the
paper thickness level may improve the situation.
The default setting for "Plain Paper" is 3.
The default setting for "Recycled Paper" is 3.
The default setting for "Translucent Paper" is 2.
The default setting for "Film" is 3.
For information on the available settings, see the table titled "Paper Thick-
ness: Paper Tray."
❖ Paper Volume
Specify the initial remaining volume of roll paper to be displayed for each pa-
per tray.
The system monitors the amount of paper used, and automatically determines
the remaining volume, based on the specified initial remaining volume.
We recommend that you specify an appropriate remaining volume each time
a paper tray is loaded.
Select "New (Full)" when a paper tray is loaded with a new 150 m roll of paper.
The default setting is New (Full).
Reference
p.3 "Accessing User Tools"
Tray Paper Settings
45
2