Ricoh Aficio MP W3600 General Settings Manual page 46

System Settings
To set the Fine Ratio setting, measure the length of the original and the copy
image to calculate the ratio.
2
❖ Fine Ratio Adjustment: Printer
Specify the fine ratio when the optional printer is installed. Depending on pa-
per type, environment, and humidity, copy paper can expand or shrink
slightly. This means that the size of the copy and the original do not match.
When the horizontal ratios are almost the same and there are differences be-
tween the vertical ratios, you can specify the vertical correction ratio. You can
make this setting for each paper type (plain, translucent, film and recycled pa-
per).
The default setting is 0.0%.
Specify the ratio between –1.0% and 1.0% (in 0.1% increments).
For details about how to set the fine ratio, see "Fine Ratio Adjustment: Copier".
❖ Adjust Scan Position
You can adjust the position of the scan area.
The default setting is 0.
Specify the scan position between –10 and +10 (in 1 increments).
❖ System Status/Job List Display Time
Specify how long to display the System Status and Job List display for.
The default setting is On, 15 second(s).
By selecting [On], you can specify a display time between 10 and 999 seconds.
❖ Key Repeat
You can enable or disable repetition of an operation if a key on the screen or
control panel is pressed continuously.
The default setting is Normal.
38
ZEDG010E