Table of Contents
Advertisement
Connecting Other Sources
Connecting the antenna terminals
An FM antenna cable plug can be connected directly to the unit.
Direction of broadcasting
station
AM loop
FM antenna
(Supplied)
75
/ohm
COAXIAL
cable
FM indoor
antenna
(Supplied)
AM outdoor antenna
Ground
2 AM loop antenna assembly
Connect to the AM
antenna terminals.
1
2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. Antenna placed on
a stable surface.
Mount
b. Hanging the
antenna on a wall.
Use the
installation hole to secure the antenna to a wall, etc.
antenna
Note to CATV system installer:
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC which
provides
guidelines
for
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is
used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna
lead terminals do not touch metal
parts of the panel.
Connection of AM antennas
1. Push the lever.
2. Insert the conductor.
3. Return the lever.
Connecting the XM terminal
• AVR-886 is the XM Ready ® receiver. You can receive XM Satellite Radio ® by connecting to the
XM Connect-and-Play™ (sold separately) and subscribing the XM service.
• Plug the XM Connect-and-Play antenna into XM terminal on the rear panel.
• Position the XM Connect-and-Play antenna near a south-facing window to receive the best signal.
For details, see "XM Satellite Radio" (
When making connections, also refer to the operating instructions of the XM Connect-and-Play
antenna.
proper
NOTE:
• Keep the power supply cord unplugged until the XM Connect-and-Play antenna connection
have been completed.
16
ENGLISH
Connecting Other Sources
page 32).
XM Connect-and
-Play Antenna
F
ENGLISH
Hide quick links:
Advertisement
Table of Contents
