Other Functions; Playing One Source While Recording Another (Rec Out Mode); Last Function Memory; Initialization Of The Microprocessor - Denon AVR-886 Operating Instructions Manual

ENGLISH
Advanced Operation
FUNCTION ZONE2/REC SELECT
POWER SPEAKER

Other functions

Playing one source while recording another
(REC OUT mode)
1
ZONE2/REC SELECT
Press the
the "RECOUT SOURCE" on the display.
The display switches as follows each time the button is
pressed.
ZONE2
2
FUNCTION
Turn the knob to select the source
you want to output appears on the display.
3
Set the recording mode.
For operating instructions, refer to the manual of the
component on which you want to record.
To cancel, turn the FUNCTION knob and select "SOURCE".
• Recording sources other than digital inputs selected in the REC
OUT mode are also output to the ZONE2 audio output
terminals.
• Digital signals are not output to the REC SOURCE or audio
output terminals.
• The DIGITAL IN's signal selected with the FUNCTION knob is
output to the DIGITAL OUT (OPTICAL) terminal.

Last function memory

• This unit is equipped with a last function memory which stores
the input and output setting conditions as they were
button to display
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function
provides approximately one week of memory storage when the
main unit's POWER switch is off and the power supply cord
REC
disconnected.
If the indication on the display is not normal or if the operation of
the unit is not correct, then the microprocessor should be reset
by the following procedure.
1
2
3
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
39
ENGLISH
Advanced Operation

Initialization of the microprocessor

Switch off the unit using the main unit's
POWER
switch.
SPEAKER A B
Keep both and buttons depressed
and turn on the unit by pressing the main unit's
POWER
switch.
Check that the entire display is flashing at 1-
second intervals and release the buttons.
• The microprocessor will be initialized.
reset to the default values (the values set upon shipment from
the factory).