Toyota LAND CRUISER Owner's Manual page 341

UNX503
2. Use the "TEMP" button to set the de-
sired temperature.
The "TEMP" button is used to set the desired
passenger compartment temperature. The
temperature of air delivered to the passenger
compartment will be controlled automatically
according to the setting.
SETTING OPERATION - manual control
When one of the manual control buttons is
depressed while operating in automatic
mode, the mode relevant to the depressed
button is set. Other conditions continue to
be adjusted automatically.
If manual air flow selection is desired -
The outlets from which air is delivered can be
selected manually by touching the switch.
The function of each mode is as follows:
1 Panel - Air flows mainly from the instru-
ment panel vents.
2 Bi-level - Air flows from both the floor
vents and the instrument panel vents.
3 Floor - Air flows mainly from the floor
vents.
It is recommended that you close the lower
vent. For details about this, see page 139.
AIR CONDITIONING
4
Floor/Windshield - Air flows mainly
from the floor vents and windshield
vents.
It is recommended that you close the lower
vent. For details about this, see page 139.
The selected mode is highlighted in green.
If quick heating or cooling is desired -
Push the "TEMP" button on either side and
hold it until the maximum figure or minimum
figure appears.
V
135