Toyota LAND CRUISER Owner's Manual page 190

5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate,
identify if your garage transmitter is of
the "Rolling Code" type. Press and hold
A
the programmed HomeLink
The garage door has the rolling code
feature if the indicator light (on the
A
HomeLink ) flashes rapidly and then
remains lit after 2 seconds.
garage transmitter is the "Rolling Code"
type, proceed to the heading "Program-
ming a rolling code system".
6. Repeat steps 2 through 5 for each re-
A
maining HomeLink button to program
another device.
Programming a rolling code system
If your device is "Rolling
equipped, it is necessary to
steps 1 through 4 under the heading
A
"Programming the HomeLink " before
proceeding with the steps listed below.
190
A
by 1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer
guide supplied by
opener manufacturer for the location of
this "training" button.
button. 2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 sec-
onds in which to initiate step 3 below.
If your
3. Press and release the vehicle's pro-
grammed HomeLink
The garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
Code"
follow The ceiling mounted garage door open-
er motor should now recognize the
A
HomeLink unit and be able activate
the garage door up/down.
4. Repeat steps 1 through 3 for each re-
A
maining HomeLink
another rolling code system.
Programming an entrance gate/Program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
to the owner's
2. Place
the garage door
transmitter 25 to 75 mm (1 to 3 in.)
away from
HomeLink
Keep the
HomeLink
3. Press
HomeLink
A
4. Continuously press and release (cycle)
button twice.
the hand- held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the
HomeLink
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
button to program maining HomeLink
another device.
2004 L/C100 from Aug '03 Prod. (OM60A04U)
A
but-
your hand- held gate/device
the surface of the
A
.
indicator light on the
A
in view while programming.
and hold the selected
A
button.
indicator light on the
A
changes from a slow to a
A
by
A
button to program