Toyota LAND CRUISER Owner's Manual page 191

Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
A
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
A
the HomeLink ".
A
(b) Operating the HomeLink
A
To operate the HomeLink , press the ap-
A
propriate HomeLink button to activate the
programmed device. The HomeLink
cator light should come on.
A
HomeLink continues to send the signal
for up to 20 seconds as long as the but-
ton is pressed.
(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
CAUTION
:
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other de-
vice. Make sure people and objects
are out of the way of the garage
door or other device to prevent po-
tential harm or damage.
:
Do not use this HomeLink
Transceiver with any garage door
opener that lacks the safety stop and
reverse feature as required by federal
safety standards. (This includes any
A
indi-
garage door opener model manufac-
The
tured before April 1, 1982.) A garage
door opener which cannot detect an
object (signaling the door to stop
and reverse), does not meet current
A
federal safety standards. Using a ga-
rage door opener without these fea-
tures increases risk of serious injury
or death.
A
This device complies with FCC Rules
part 15. Operation is subject to the fol-
A
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence that may be received, including
interference that may cause undesired
operation.
WARNING: This transmitter has been
A
Universal tested and complies with FCC and
DOC/MDC rules.
cations not expressly approved by the
party responsible
could void the user's authority to op-
erate the device.
2004 L/C100 from Aug '03 Prod. (OM60A04U)
Changes or modifi-
for compliance
191