Table of Contents
Advertisement
Running a program
To run (play back) a ND 1200 program:
U
Press the MENU key.
U
Press the PROG soft key. The Program screen will be displayed.
U
Use the ARROW CURSOR keys to highlight the desired program
number.
U
Press the RUN soft key. The DRO screen will be displayed and the
program will begin running. An indication of an active recording will
be shown in the upper right corner of the screen.
U
Press the VIEW soft key to show the targeting graphic screen.
Do not use the targeting graphic to perform fine
positioning of the crosshair probe. The targeting graphic is
only provided to assist rough positioning.
U
Perform the indicated measurements and other activities prompted
by the program. The program will stop running and the DRO screen
will be displayed automatically when all the program steps have
been completed.
An example of running a program is shown on the next
page.
60
1 Operation
Advertisement
Table of Contents
