Table of Contents
Advertisement
1.9 Reporting
Reporting
Reports of measurement results can be sent to a USB printer or USB
flash drive over the USB port, or to a PC over the RS-232 serial port.
Report content, destination and format are specified in the
Print, RS-232 and USB setup screens discussed in Chapter
2: Installation and Specifications.
Report types include:
Report type
Report content
Display
The data displayed on the DRO screen is sent as
one row for each axis.
Report
All feature measurement data is sent in tabular
form without tolerance data.
Tol Rpt
All tolerance data is sent in tabular form. Feature
measurement data are not sent.
CSV
All feature measurement data is sent in as comma
separated variables without tolerance data.
Tab
All feature measurement data is sent in as tab
separated variables without tolerance data.
None
No data are sent.
Sending reports
Reports can be sent at any time. To send a report:
U
Press the feature SEND key.
Reports can also be sent:
By including the send function in a program
When the Print setup screen is configured to send when an edge is
recognized
When the Measure setup screen is configured to send in response
to tolerance test results
By pressing a hot key configured in the Hot Keys setup screen to
send
72
1 Operation
Advertisement
Table of Contents
