Denon AVR-1910 Owner's Manual page 26

ENGLISH
8
Press .
This returns you to analysis results items, so repeat
step 7 .
9
Press i to select "Next", then
press .
10
ui
Press to select
"Store", then press
Step5:Store
.
Please select "Store"
to store measurement
"Storing Please wait... " is
values.
displayed on the on-screen
display while the results
are being stored.
When storing is complete,
[ENT]:Store
"Storing complete. Auto
Setup is now finished. " is
displayed on the on-screen Step5:Store
display.
b
If you do not want to save
the measurement results,
use ui to select "Cancel" ,
then select "Yes" using
o p . All the measured
Audyssey Auto Setup data
will be erased.
NOTE
Do not turn the power off while the settings are being stored.
12
Disconnect the setup microphone from the AVR-
1910.
2
NOTE
Do not change the speaker connections or subwoofer volume, or
speaker locations after making measurements. If changes are neces-
Front
sary, make the changes and use the Audyssey Auto Setup once again
for an updated EQ solution.
• If the result differs from the actual connection status or an error mes-
sage appears, use
to repeat the measurement.
MultEQ
• If the result still differs from the actual connection status after re-
measurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-1910 off,
check the speaker connections and repeat the measurement pro-
Store
cess from the beginning.
Cancel
• For instance, If the location or direction of a speaker is altered, the
Audyssey Auto Setup should be performed again to ensure the cor-
⇩
rect EQ solution for the new room configuration.
MultEQ
Storing
Please wait...
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
ui to on-screen display "Retry" and then press