Once Connections Are Completed; Turning The Power On; Connecting The Power Cord; Turning The Power Off - Denon AVR-1910 Owner's Manual

ENGLISH
Antenna terminals
Direction of broadcasting station
FM antenna
75 Ω/ohms
Coaxial cable
FM indoor antenna
(supplied)
AM outdoor antenna
Ground
n AM loop antenna assembly
1
Remove the vinyl tie and take out the
connection line.
2
Bend in the reverse direction.
3
-1 W ith the antenna on top of any
stable surface.
Mount
3
-2
With the antenna attached to a
wall.
Installation hole Mount on wall, etc.
n Connection of AM antennas
1
Push the lever.
2
Insert the conductor.

Connecting Devices not Equipped with HDMI terminals
3
Return the lever.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
AM loop
loop antenna.
antenna
• Make sure the AM loop antenna lead terminals do not touch metal
(supplied)
parts of the panel.

Connecting the Power Cord

Wait until all connections have been completed before connecting the
power cord.
Power cord
Connection to the AC outlets
• These outlets supply power to external au-
dio equipment.
• Audio equipment with a total power con-
sumption of 120 W (1 A) can be connect-
ed.
• The power supply turns on and off together
with the
to "ON" , power is supplied from the outlet.
When set to "STANDBY" , no power is sup-
plied.
NOTE
When "HDMI Control" (vpage 28) is set
to "ON" , power is supplied constantly to
the AC outlet (UNSWITCHED).
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlets to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Once Connections are
Completed

Turning the Power On

1
Press
The power indicator lights red and the
power is set to the standby mode.
2
Press
The power indicator flashes green and the
power turns on.
b Also press
mode, the power turns on.
When
stored in the memory for the quick select function is set (vpage
50 "Saving frequently used settings (Quick Select Function)").
This operation can also be performed by pressing a
To household
the main unit.
power outlet
(AC 120 V, 60 Hz)

Turning the Power Off

1
Press .
The power is set to the standby mode.
2
Press
on the main unit. When set
The power indicator turns off, and so does
the power.
NOTE
• Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long
periods of time or when traveling, either press
power, or unplug the power cord from the power outlet.
• When the ZONE2 power is switched on, and you want to switch off
the MAIN ZONE power, press
.
.
when in standby
has been pressed, the input source set with the
is set. If a has been pressed, the input source
.
to turn off the
.
Front
on
Front