Lexicon PCM 81 - REV User Manual page 58

Let's modify the patch further by adjusting the Destination values to a more
useful range.
Press Load/ repeatedly until the Patch 1 Values screen is displayed.
Patch 1
000
Notice that the is to the left of the Source value. This indicates that the Source
value is selected and its value will be changed when you turn ADJUST.
Press Load/ once to move the
is in this position, ADJUST will change the Destination value.
Patch 1 Values
000 –360 MONO
The asterisk ( ) indicates that the Source value
will be altered when you turn ADJUST.
With the Destination value selected, turn ADJUST clockwise to set the value to
+0.
Patch 1
000 :
Next, we'll want to adjust the Destination value when the LFO is at its maximum
value. One way to do this is to press Load/
display of the Source value, and continue on from there — but we've provided
a short cut! Press Edit to jump to the next assigned value ( in our example, the
LFO maximum value).
Patch 1
127 :
Note that the remains in the same position, so you can just turn ADJUST to
set the new Destination value. Set the value to +90.
Patch 1
127 :
Now our example has been modified so that the LFO sweeps the FX Width Value
from 0 to 90. This creates a dynamic alteration of the effect's spatial character-
istics. Its stereo image changes smoothly from mono to stereo, to surround, and
back again.
Values
–360 MONO
to the right of the Source value. When the
Patch 1 Values
000 : –360 MONO
Press Load / to move the asterisk to this position,
where it indicates that Destination values will be
altered when you turn ADJUST.
Values
+0 MONO
three times to cycle the
Values
+360 MONO
Values
+90 L-R, R-L
Changing the default
destination values
to the
Basic Operation
2-37