Lexicon PCM 81 - REV User Manual page 56

Press Load/ to bring up patch Destinations for selection. The display should
show that Destination is unassigned.
The ADJUST knob will now scroll through all of the available parameters of
EkoChorus. The lower line of the display will show the edit matrix row label on
the left, and the parameters in that row on the right.
Turn ADJUST clockwise until FX Width (in the effect's Controls row) is
displayed in the lower right corner of the display.
The FX Width parameter is now assigned as the patch Destination.
Now, press Load/ to bring up the Values display. This will show the default
Destination value setting (–360 MONO). This is the value assigned to FX Width
when the LFO is at its minimum value (000).
Turn ADJUST one click counterclockwise to display the default Destination
value (+360 MONO) assigned to FX Width when the LFO is at its maximum value
(127).
That's all there is to setting up a default patch— select a Source and Destination,
and the minimum and maximum patch values are set automatically.
Of course, you will often want to modify the patch further, either by adjusting the
modulation source parameters, changing the default values or adding additional
pivot points. In the following sections, we'll continue using this patch to
demonstrate examples of these modifications. When we're done, the new patch
will add dynamic spatialization to the EkoChorus program.
Patch 1 Dst
Unassigned
Patch 1 Dst
Controls FX Width
Patch 1 Values
000 –360 MONO
Patch 1 Values
127 +360 MONO
Basic Operation
2-35