HP P4522A - Traffic Management Server Sa8220 User Manual page 231

C H A P T E R 6
NOTE: We recommend
that you test the
connectivity using
Brokered mode before
switching to OPR mode.
Verify that the VIP is
accessible from the client
before enabling OPR
mode.
Add HTTP Service and VIP
1. To add HTTP service (with a virtual IP address of 10.1.1.201 on
port 80) to policy group oprtest, type this command:
HP SA8220/config/policygroup/oprtest#
service create OPR vip 30.1.1.201 port 80
This command creates a new service on the SA8220, using the
HTTP protocol, at IP address 30.1.1.201, listening on TCP port
80.
2. To move the prompt, type this command:
HP SA8220/config/policygroup/oprtest#service OPR
Add Servers to the OPR Service
1. To add the server "Serv1.com" to the OPR service, type this
command:
HP SA8220/config/policygroup/oprtest/service/
OPR#server create serv1.prime.com port 80
Server serv1.prime.com port 80 has been created.
This command tells the SA8220 that serv1.prime.com can fulfill
requests arriving at 10.1.1.201 on port 80.
2. To move the prompt, type this command:
HP SA8220/config/policygroup/oprtest/service/
OPR#serv1.prime.com port 80
3. Finish by typing this command:
HP SA8220/config/policygroup/oprtest/service/
OPR/serv1.prime.com/port/80#mode opr
This command allows client addresses to be forwarded to the
server rather than to the SA8220's address.
e-Commerce Appliance Scenarios
219