Verify Failure - Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual

Verify Failure

S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
Verify Failure
Verify failure has many possible causes:
•
•
•
•
•
Note Use the show switch-profile status command to view messages about the failure.
Determine if the failure is on local/peer side by looking at whether the error is listed under local error(s)/
Note
peer error(s) or both.
Use the show system internal csm info trace command to view events, trace, and error messages.
Note
Mutual exclusion check under local information
Possible Cause
Command failed mutual-exclusion check under local information because the command has already
been configured from conf-t.
Solution
Delete the command from conf-t mode and run verify from config-sync mode.
Mutual exclusion check under peer information
Possible Cause
Command failed mutual-exclusion check under peer information because the command has already been
configured from conf-t on the peer.
Solution
Delete the command from conf-t mode on the peer and run verify from config-sync mode.
Rollback/ISSU in progress
Possible Cause
Verify cannot be performed when rollback/ISSU is in progress.
Solution
Stop rollback or wait for it to complete and run verify.
Cisco Nexus 5000 Series Troubleshooting Guide
9-8
Mutual exclusion check under local information
Mutual exclusion check under peer information
Rollback/ISSU in progress
Global-db modification in progress
Peer unable to accept lock request
Chapter 9 Troubleshooting Config-Sync Issues
OL-25300-01