Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual page 20

Fabric Manager Tools and CLI Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
switch# show monitor session 1
session 1
---------------
type
state
source intf
source VLANs
source VSANs
destination ports : fc3/2
Suspending the SPAN Session
Example:
switch(config)# monitor session 1 suspend
switch(config)# show monitor session 1
session 1
---------------
type
state
source intf
source VLANs
source VSANs
destination ports : fc3/2
Debugging
Command-Line Debugging
Available debugs depend on features enabled in NX-OS. There are many different options to select when
turning on debugs.
Determine the destination of the output:
•
•
You must have administrator privileges to run debugs. Debugs can only be run from the CLI.
Debug Logging
Set the log file as CiscoLive_debugs, using the debug logfile command. Then, use the show debug
command to see name of the debug file.
Cisco Nexus 5000 Series Troubleshooting Guide
1-12
: local
: up
:
rx : fc3/1
tx : fc3/1
both : fc3/1
:
rx :
:
rx :
: local
: down (Session suspended)
:
rx : fc3/1
tx : fc3/1
both : fc3/1
:
rx :
:
rx :
Logfile—Data file in switch memory.
Capture to direct to screen via console, Telnet, or SSH.
Chapter 1 Troubleshooting Overview
OL-25300-01