Memory Offset Tuning; Deleting Memories - Yaesu FT-270R Operating Manual

M M
EMORY
Once you have recalled a particular memory channel, you may easily tune off that channel,
as though you were in the "VFO" mode.
1. With the FT-270R in the "MR" (Memory Recall) mode, select
the desired memory channel.
2. Press the [ MR/MW ( SKIP )] key momentarily to activate the
"Memory Tuning" feature. The Memory Channel number will be
tun
replaced by "
played on the memory channel, the display will automatically
revert to display of the operating frequency, so you can navi-
gate without having to enter the Menu to change the display
configuration.
3. Rotate the DIAL knob, as desired, to tune to a new frequency.
The synthesizer steps selected for VFO operation on the current
band will be the steps used during Memory Tuning.
4. If you wish to return to the original memory frequency, just press
the [ MR ( SKIP )] key momentarily. The display will revert to dis-
play of the alpha-numeric Tag (if any) that may have originally
appeared on the LCD.
5. If you wish to store a new frequency set during Memory Tuning, just press and hold
in the [ F/L ] key for one second, per normal memory storage procedure. The micropro-
cessor will automatically set itself to the next-available clear memory location, and you
then press [ F/L ] again to lock in the new frequency.
1) If you want to replace the original memory contents with those of the new
frequency, be sure to rotate the DIAL knob to the original memory channel
number!
2) Any required CTCSS/DCS changes, or repeater offset modifications, must be done
before storing the data into the new (or original) memory channel location.
You may delete any of the memories (except for Memory Channel "1" and the Home Chan-
nel). The procedure for deleting a channel is quite simple.
1. Press the [ VFO ( PRI )] key, if needed, to enter the MR mode.
2. Press and hold in the [ MR/MW ( SKIP ) key for one second, then rotate the DIAL knob
to select the memory channel to be deleted.
3. Press the [ F/L ] key momentarily. The display will revert to memory channel #1. The
previously-selected memory will be deleted.
Important Notice! Once deleted, the channel data cannot be recovered!
32
ODE
M
." And if you have an alpha-numeric Tag dis-
D
O T
M
FT-270R O M