Yaesu FT-270R Operating Manual page 84

S M M
ET ENU ODE
Set Mode Item 50 VFO.SPL
Function: Enables or disables "VFO Split" operation.
Available Values: VSP.OFF/VSP. ON
Default: VSP.OFF
Set Mode Item 51 WID.NAR
Function: Select Wide (±5 kHz) or Narrow (±2.5 kHz) TX Deviation.
Available Values: WIDE/NARROW
Default: WIDE
Note: If "Narrow" is selected, the receiver audio level is increased slightly to compensate
for the reduced deviation. The receiver IF filter bandwidth is not changed via this setting.
Set Mode Item 52 WX ALT
Function: Enables/Disables the Weather Alert Scan feature.
Available Values: ALT.OFF/ALT. ON
Default: ALT. OFF
The following Set Mode Items will appears when the optional FTD-7 DTMF Paging Unit
is installed.
Set Mode Item 53 ANI
Function: Enables/Disables the ANI function.
Available Values: ANI.OFF/ANI. ON
Default: ANI. OFF
Set Mode Item 54 ANI.WRT
Function: Program the ANI Identifier.
See page 57 for details.
Set Mode Item 55 PAGER
Function: Enables/Disables the ANI function.
Available Values: PAG.OFF/PAG. ON
Default: PAG. OFF
Set Mode Item 56 PAG.COD
Function: Setting the Pager Code for the DTMF Pager.
See page 55 for details.
Set Mode Item 57 PAG.ABK
Function: Enables/Disables the Answer Back function of the DTMF Pager.
Available Values: ABK.OFF/ABK. ON
Default: ABK. OFF
80 FT-270R O M