Keypad/Lcd Illumination; Disabling The Keypad Beeper - Yaesu FT-270R Operating Manual

Your FT-270R includes a reddish illumination lamp which aids in nighttime operation. The
reddish illumination yields clear viewing of the display in a dark environment, with minimal
degradation of your night vision.
Three options for activating the lamp are provided:
KEY
Mode:
CONT
Mode: Illuminates the Keypad/LCD lamp continuously.
OFF
Mode:
Here is the procedure for setting up the Lamp operating mode:
1. Press the [ F/L ] key, then press the [ 0 ( SET )] key to enter the Set
mode.
2. Rotate the DIAL knob to select Set Mode Item 25:
3. Press the [ F/L ] key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to select one of the three modes described
above.
5. When you have made your choice, press the PTT switch to save the new setting and
return to normal operation.
A keypad beeper provides useful audible feedback whenever a keypad is pressed.
If you want to turn the beep off:
1. Press the [ F/L ] key, then press the [ 0 ( SET )] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 6:
3. Press the [ F/L ] key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to change the setting to "
5. Press the PTT switch to save the new setting and return to
normal operation.
6. To turn the beep back on again, select "
(factory default)" in step 4 above.
KEY
: The beeper sounds when you press the keypad.
KEY+SC
: The beeper sounds when you press the keypad, or when the scanner stops.
FT-270R O
K /LCD I
Illuminates the Keypad/LCD lamp for five seconds when you rotate the
DIAL knob or press the keypad or any switch (except PTT switch).
This is the factory-programmed default setting.
Disables the Keypad/LCD lamp.
D
M
A
DVANCED
LAMP
.
K B
BEEP
.
OFF
."
KEY KEY+SC
" or "
O
PERATION
17