Yaesu FT-270R Operating Manual page 78

S M
ET ENU
Set Mode Item 17 DT WRT
Function: Programming of the DTMF Autodialer.
See page 53 for details.
Set Mode Item 18 ECS.CDR
Function: Setting the Receiver Pager Code for the Enhanced CTCSS Paging & Code
Squelch.
See page 26 for details.
Set Mode Item 19 ECS.CDT
Function: Setting the Transmitting Pager Code for the Enhanced CTCSS Paging & Code
Squelch.
See page 26 for details.
Set Mode Item 20 EDG.BEP
Function: Enables/Disables the Band-edge beeper while selecting the frequency via the
DIAL knob.
Available Values: BEP.OFF/ BEP. ON
Default: BEP.OFF
Set Mode Item 21 EMG S
Function: Selects the alarm(s) utilized when the Emergency function is engaged.
Available Values: EMG.BEP/EMG.LMP/EMG.B+L/EMG.CWT/EMG.C+B/EMG.C+L/
EMG.ALL/OFF
Default: EMG.B+L
EMG.BEP: Loud "Alarm" sounds.
EMG.LMP: The LCD/Keypad lamp flashes.
EMG.B+L: Loud "Alarm" sounds and the LCD/Keypad lamp flashes.
EMG.CWT: Transmits the Morse Code "SOS" (• • • – – – • • •) message on the air begin-
ning one minute after activation of the Emergency function.
EMG.C+B: Loud "Alarm" sounds and the Morse Code "SOS" (• • • – – – • • •) message is
transmitted on the air beginning one minute after activation of the Emergency
function.
EMG.C+L: The LCD/Keypad lamp flashes, and the Morse Code "SOS" (• • • – – – • • •)
message is transmitted on the air beginning one minute after activation of the
Emergency function.
EMG.ALL: All of the above are activated.
OFF: Disables the Emergency function. The Emergency function also cannot be en-
gaged, by pressing and holding in the [ 4 ( RPT )] key, if this Menu is set to "OFF."
When the radio is set to the EMG.CWT, EMG.C+B, EMG.C+L, or EMG.ALL mode, the
radio will be instructed to send "DE (your callsign)" after the sending of the SOS message,
if your callsign is entered via Set Mode Item 10:
74
M
ODE
CWID
.
FT-270R O M