Memory Offset Tuning - Yaesu FT-252 Operating Manual

4. Rotate the DIAL knob or press the [ p ] / [ q ] key to set this to "
the alpha-numeric "Tag" display) .
5. To display the frequency again, just repeat the above procedure.
6. When you have made your selection, press the PTT switch to save the setting and
exit to normal operation.
To display the frequency again on all memory channels, just repeat the above procedure,
rotating the DIAL knob or press the [ p ] / [ q ] key to select "
2) Direct Setting:
1. Set the FT-252 to the "MR" (Memory Recall) mode, and recall the memory channel
on which you wish to enable the alpha-numeric Tag.
2. Press and hold the [ F/MW ] key for one second.
3. To display the frequency again, just repeat the above procedure.
This procedure is only applied directly to the memory channel on which you are cur-
rently operating (all other memory channels are unchanged).
Once you have recalled a particular memory channel, you may easily tune off that chan-
nel, as though you were in the "VFO" mode.
1. With the FT-252 in the "MR" (Memory Recall) mode, select the desired memory channel.
2. Press and hold the [ REV ] key for one second to activate the "Memory Tuning" fea-
ture. The Memory Channel number will be replaced by
" ." And if you have an alpha-numeric Tag displayed
tun
on the memory channel, the display will automatically
revert to display of the operating frequency, so you can
navigate without having to enter the Menu to change the display configuration.
3. Rotate the DIAL knob, as desired, to tune to a new frequency. The synthesizer steps
selected for VFO operation will be the steps used during Memory Tuning.
4. If you wish to return to the original memory frequency, just press the [ V/M ] key mo-
mentarily. The display will revert to display of the alpha-numeric Tag (if any) that
may have originally appeared on the LCD.
5. If you wish to store a new frequency set during Memory Tuning, just press and hold
in the [ F/MW ] key for one second, per normal memory storage procedure. The mi-
croprocessor will automatically set itself to the next-available clear memory loca-
tion, and you then press [ F/MW ] again to lock in the new frequency.
1) If you want to replace the original memory contents with those of the new frequen-
cy, be sure to rotate the DIAL knob to the original memory channel number!
2) Any required CTCSS/DCS changes, or repeater offset modifications, must be done
before storing the data into the new (or original) memory channel location.
FT-252 O
peraTing

Memory Offset Tuning

M
anual
Memory Mode
ALPHA
" in step 4 above.
FREQ
" (enabling
25