Memory Bank Scan - Yaesu FT-270R Operating Manual

S
CANNING

Memory Bank Scan

When the Memory Bank feature is engaged, the scanner sweeps only memory channels in
the current Memory Bank. However, if the Memory Bank Link Scan feature is enabled,
you may sweep the memory channels in several Memory Banks which you have selected.
To enable the Memory Bank Link Scan feature:
1. Set the radio to the Memory mode by pressing the [ MR/MW ( SKIP )] key, if necessary.
2. Press and hold in the [ VFO ( PRI )] key for one second, then rotate the DIAL knob to
select the first Memory Bank ("
Memory Bank Link Scan.
3. Press the [ F/L ] key momentarily. The current Memory Bank will
now be swept during Memory Bank Scan. A "decimal point"
will be appended between the "
number indication (such as
4. Repeat steps 2 and 3 above, to append the "decimal point" to any other Memory Banks
you wish to sweep.
5. Now, press and hold in the [ MR/MW ( SKIP )] key for one second to initiate the Memory
Bank Link Scan.
6. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 2 and 3
above, to delete the "decimal point" from the Memory Bank number indication.
40
M S
BANK 1
" ~ "
N K
" and " " of the Memory Bank
BAN.K 2
).
BANK10
") you wish to sweep using
FT-270R O M