Simrad ER60 - REV B Operator's Manual page 164

Simrad ER60 Operator manual
156
The server application will respond with a Response message.
The GetParameter method has the following output
parameters.
Parameter name
Value
Time
An example of the contents of the Response field of a
GetParameter command to the ParameterServer is shown
below.
<response>
<clientInfo>
<cid dt="3">1</cid>
<rid dt="3">28</rid>
</clientInfo>
<fault>
<detail>
<errorcode dt="3">0</errorcode>
</detail>
</fault>
<GetParameterResponse>
<paramValue>
<value>60</value>
<time>0</time>
<paramValue/>
<GetParameterResponse/>
</response>
Set parameter
The method part of the request shall be set to SetParameter.
The SetParameter method has the following input parameters.
Parameter name
paramName
paramValue
paramType
An example of the contents of the Request field of a
SetParameter command to the ParameterServer is shown
below.
<request>
<clientInfo>
<cid>1</cid>
<rid>28</rid>
</clientInfo>
<type>invokeMethod</type>
Description
The value of the parameter
The time when the parameter was
urpdated
Description
Full name of the current
parameter
The new value to update the
parameter with
The data type of the paramValue
field
850-164692 / Rev.B