Recording A Loop Using Auto Record - DigiTech JAMMAN - MANUAL 2 Owner's Manual

Recording a Loop Using Auto Record

The JamMan
®
recording when signal is detected at any of the JamMan Stereo's inputs.
NOTE: The maximum loop time the JamMan Stereo can record or play is
10 minutes. You can't auto-record on an existing loop; Auto Record is only
available when an empty loop memory is selected.
Here is how to use Auto Record when recording a loop.
1. Select an empty memory location using the
LooP UP/LooP DoWN
off). If the
on the optional memory card.
2. Press the
3. Press the
Rec/PLaY/oVeRDUb
flashing red indicating the JamMan Stereo is armed for recording.
4. Begin playing a phrase on your guitar. The
footswitch and
recording is now taking place.
5. When you are finished recording, press the
footswitch once to set the loop point and have the phrase play back
in a repeating loop. The
LEDs will light solid green.
6. Press the
Once you are finished recording, the
phrase must be stored to memory to be recalled later.
28
Stereo has an Auto Record feature that automatically starts
footswitches (the
LED is lit, you have selected an empty location
caRD MeM
button so it is lit.
aUto Rec
Rec/PLaY/oVeRDUb
footswitch and
RecoRD
footswitch to stop the loop playback.
teMPo/stoP
LooP
footswitch to arm record. The
RecoRD
status LEDs will light solid red to indicate
Rec/PLaY/oVeRDUb
button will be lit indicating the
stoRe
knob or
LooP seLect
and LEDs will be
sINgLe
status LEDs will be quickly
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
footswitch and status
PLaY