Erase All Loops - Memory Card - DigiTech JAMMAN - MANUAL 2 Owner's Manual

Erase All Loops - Memory Card

The Erase Loops procedure only erases JamMan Stereo loop data from a
memory card. All other data and files on the card are left untouched.
To erase all loops from an optional SD/SDHC memory card, follow these steps:
1. Install an optional SD/SDHC memory card in the JamMan Stereo's
memory card slot on the rear panel.
2. Select a loop memory location that lights the
3. Enable the
4. Press and hold the
Memory Card Loops) appears in the
show briefly first but keep holding the button until EC appears). The
DeLete
5. Press the
The
DeLete
press the
6. To erase all loop data, press and hold the
more seconds. The
erased.
NOTE: If when you try to delete a loop from
SD card the display flashes CP, the SD copy
protection switch is in the "Locked" position.
56
button.
sHIft
DeLete
button will begin flashing.
button again. The
DeLete
button will continue to flash. To abort this procedure,
button.
eXIt
DIsPLaY
button for four seconds until EC (Erase
DIsPLaY
DIsPLaY
DeLete
will show Bu indicating the card is being
LED.
caRD MeM
and release (EL will
reads E? (Erase Loops?).
button for two
Unlocked
SD
Locked Card