3Com LSBM1SRP1M1 Installation Manual page 99

Installation Manual
H3C S9500 Series Routing Switches
host inet (h)
gateway inet (g)
user (u)
ftp password (pw) (blank = use rsh):
flags (f)
target name (tn)
startup script (s)
other (o)
Write flash...done!
6) After you provide the required information, the system accesses the Ethernet
interface submenu again:
1. Download file to SDRAM through ethernet interface and boot
2. Download file to Flash through ethernet interface
3. Download file to CF card through ethernet interface
4. Modify ethernet interface boot parameter
0. Return to main menu
Enter your choice(0-4): 2
7) At the prompt displayed in the last step, select a place for retaining the
downloaded file (the Flash for example by entering 2), press Enter, and the
system will display the following information in the terminal:
Attached TCP/IP interface to fei0.
Attaching network interface lo0... done.
boot device
unit number
processor number
host name
file name
inet on ethernet (e) : 1.1.1.1
host inet (h)
flags (f)
Prepare for loading....OK
Loading......done
Free CF card space : 203915264 bytes
Writing CF card.....
......Done
8) The information displayed in the last step means a successful file downloading
operation. In this case, the system accesses the Ethernet interface submenu
again and the user can make selection as needed. The details will not be covered
here.
: 1.1.1.2
:
:
:0x80
:
:
:
ETHERNET SUBMENU
: fei0
: 0
: 0
: 9500
: 9500.app
: 1.1.1.2
: 0x80
Chapter 5 Switch Monitoring and Maintenance
5-21