Connecting Fiber - 3Com LSBM1SRP1M1 Installation Manual

Installation Manual
H3C S9500 Series Routing Switches

3.9.5 Connecting Fiber

I. Installing fiber management tray (optional)
Note:
The installation method described below is based on an N68 cabinet. The installation
procedure is only for your reference if you use a non-N68 cabinet.
A fiber management tray (FMT) is installed in a cabinet for winding redundant fibers
between the S9500 and other devices.
1) Preparations
The installation prerequisites are as follows:
The cabinet is fixed well.
The device has been installed completely.
The installation involves the following materials:
FMT
M5×10 self-tapping screws (two screws for one FMT)
2) Installation Procedure
To install the fiber management tray, proceed as shown in Figure 3-26.
Align the fiber management tray and the installation holes on the column of the
cabinet.
Use a Phillips screwdriver to fix each fiber management tray with two M5×10
self-tapping screws.
3-24
Chapter 3 Switch Installation