Cisco SPA-841 - Sipura VoIP Phone Administration Manual page 54

Configuring Your System for ITSP Interoperability
Network Address Translation (NAT) and Voice over IP (VoIP)
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Administration Guide
Scroll down to the NAT Support Parameters section, and then enter the following
settings to enable and support the STUN server settings:
•
Handle VIA received: yes
•
Handle VIA rport: yes
•
Insert VIA received: yes
•
Insert VIA rport: yes
•
Substitute VIA Addr: yes
•
Send Resp To Src Port: yes
•
STUN Enable: Choose yes.
•
STUN Server: Enter the IP address for your STUN server.
Click Voice tab > Line
Scroll down to the NAT Settings section.
•
NAT Mapping Enable: Choose yes.
•
NAT Keep Alive Enable: Choose yes (optional).
Your ITSP may require the SPA device to send NAT keep alive messages to
NOTE
keep the NAT ports open permanently. Check with your ITSP to determine
the requirements.
Voice tab > SIP > NAT Support Parameters
N , where N is the number of the line interface.
Voice tab > Line N > NAT Settings
3
52