Yamaha RX-A3000 Owner's Manual page 50

SOURCE RECEIVER
When "E-7" or "E-8" is displayed:
Press iENTER.
1
AV
1 2 3 4
5 6 7 V-AUX
AUDIO
1 2 3 4 2 Check that the environment is suitable for
PHONO MULTI USB NET accurate measurement.
DOCK TUNER SIRIUS
[ A ]
iCursor E
3 Press
Press iENTER
4
i
ENTER ENTER
When "E-5" or "E-9" is displayed:
Press iENTER.
1
2 Check that the environment is suitable for
accurate measurement.
to select "RETRY." 3 Press
PROCEED:
When "E-5" is displayed, measurement can proceed.
to use YPAO again.
However, the measurement in noisy environment may
reduce the accuracy.
When "E-9" is displayed, resume the aborted step.
RETRY:
Restart measurement from the beginning.
Press
4
option.
When "E-10" is displayed:
Press iENTER.
1
2 Press
3 Press
switch the unit to standby mode.
Turn on the unit and use YPAO again.
4
Setting up the speaker parameters automatically (YPAO)
iCursor D / E
to select a option.
iENTER
to execute the selected
iCursor E
to select "EXIT."
iENTER
to terminate YPAO, and
CONNECTIONS
■
When a warning message is
displayed after measurement
See "Warning messages" (☞p. 51) for instructions on
resolving the problem. The speaker causing the problem
can be confirmed from the TV screen display.
NOTE
Although the results of acoustics measurement can be
applied when a warning message is displayed, optimal
sound will not be achieved. Resolving the problem
and using YPAO to measure acoustics again is
recommended.
To exit YPAO with some options
iCursor B / C
Use to select "Save/Exit"
1
and press iENTER.
iCursor D / E
2 Use to select one of the
following options and press iENTER.
SAVE:
Exits YPAO applying the results of measurement.
CANCEL:
Returns to the previous screen (warning message
screen).
EXIT:
Exits YPAO without saving the results.
En
50